Category Archives: FPC

Apr22
HotBar FPC Design Notices

發表於 April 22, 2015

The HotBar soldering is a kind of selective soldering solution where connect two pre-fluxed, solder coated parts by pulse heating element, call a “thermode”, with proper temperature to melt the solder and re-solder. Applying a pressure and contacting on the … Continue reading →

Design, FPC     WorkingBear    Views (8,277)     comment (0)
,

Apr21
Design for Flex cable(FPC) Trace Pattern

發表於 April 21, 2015

Many FPCB designer are not familiar with the manufacturer process and limitation.  I always found design does not meet DFx requirement and insist on their design and finally bring lot of quality issue after mass production. Here I ask FPCB … Continue reading →

Design, FPC, Quality     WorkingBear    Views (3,848)     comment (0)

Apr20
Screen-Printing on PET(PolyEthylene Terephthalate) notices

發表於 April 20, 2015

The PTF uses silk-screen to print the silver and carbon combination conductive inks on PET substitute to reach lower cost purpose as compare with FPC (Flexible Printing Circuit). Unfortunately, the screen-printing still has some ability limits. Especially that it has … Continue reading →

Design, FPC, Manufacture     WorkingBear    Views (3,992)     comment (0)
,

Apr20
What is PTF(Polymer Tick Film)? PTF introduction

發表於 April 20, 2015

Polymer Thick Film (PTF) flexible circuits are manufactured by screen-printing conductive ink onto flexible substrates such as PET (Polyethylene terephthalate). It can be single layer or multi-layers circuit by further screen-printing dielectric materials as insulating layer and applying through-hole technologies. … Continue reading →

FPC, Material Introduction     WorkingBear    Views (8,751)     comment (0)